3500/22M Long Distance Dual Communication

3500/22M the upper and lower two lines of digital tubes respectively represent the cutting length and the number of cuts to be controlled, and the set line will be indicated by blinking, and the input position can be switched by pressing the “Start OK” key. Input numbers can directly modify the corresponding parameters. If there is a mistake during the input process, you can press the “Cancel” key to delete the entered data and return to the display of the original parameters. If the control quantity is set to 100

3500/22M operation mode:
1-Press the “Control Setting” key to enter the “Control Parameter Setting Status” in the manual state.
2-Press the “Start OK” key to make the lower line display (number of controls) blink.
3 – Key in the following sequence: “1 key”, “0 key”, “0 key”.
4-Press the “Start OK” key to write the entered parameters to the controller. Data setting is completed, press “reset” key to exit the “control parameter” setting state.
5 Press “Clear Quantity” to clear the current number of sheets; press “Clear Length” to clear the current length.

The 3500/22M is fully integrated into existing systems. Thanks to the macro codes on the loading panel and the user-friendly software tools, the T9451 is the most user-friendly high voltage inverter available.The T9451 provides an open communication system to connect to a PLC or DCS system and can be interfaced with a wide range of communication protocols.The connections are made using a simple two-wire system, eliminating the need for expensive hardwired connections.