Bently 60M100-00 Step Instruction Ladder Diagram

60M100-00 When designing ladder diagrams with stepping instructions, it is important to pay attention to the setting of the plc initial status relays. The general plc status relays are divided into initial status relay, zero return status relay, general status relay, hold status relay and alarm status relay. The use of status relay is not limited, when the status relay is not used for step sequence control, it can also be used as an auxiliary relay.

60M100-00 When programming with a ladder diagram, circuit blocks with many series connections should be placed as far up as possible, and circuit blocks with many parallel connections should be placed as far to the left as possible, which saves instructions and is aesthetically pleasing. The use of the same numbered coil twice and more in the same programme is known as a double coil. Double coils are very likely to cause false action and should be avoided. Contacts should be drawn on the horizontal line, and branch lines that do not contain contacts should be placed in the vertical direction, not in the horizontal direction, so as to make it easier to read the diagrams and the graphics beautiful. Coils and command boxes cannot normally be connected directly to the left busbar, this can be done by special relays if required.

The 60M100-00’s coded plc programming is going to take a lot of learning and practice. Programming is completed, to carry out indoor simulation debugging, can be carried out with the help of analogue switches and plc output output indicator. Need analogue signal i/o, available potentiometer and multimeter with. Debugging, you can use peripheral equipment to simulate a variety of field switches and sensors state, and then observe the plc output logic is correct. The current plc products can be programmed on the pc, and direct simulation debugging.