MVI56-PDPMV1 Remote Computer


Product Features
>> Industrial signal isolation and long-distance transmission – term transmission
>> Equipment operation monitoring

>> Sensor signal measurement
>> Industrial Data Acquisition and Recording
>> Medical and Industrial Product Development
>> Switching Signal Acquisition

Categories: ,
Get a quote, please contact me immediately:
Simon Zhang
Phone/Whatsapp/Skype/Wechat: +86 133 6590 9307


MVI56-PDPMV1 Remote Computer

After MVI56-PDPMV1 selects the completion of automatic metering, the operator clicks on the button of the required metering well in the metering control table, and after confirming, the upper computer sends out a command, and the SunyPLC250 Auto will automatically meter the well. Measurement, first switch its three-way valve to the measurement position, to the separator into the liquid, when the liquid level reaches the measurement of the lower limit began to time, when the liquid level rises further, reaching the measurement of the upper limit, the measurement of the time is noted, and then open the drain valve, close the separator gas outlet valve, begin to drain the liquid, the three-way valve to switch to the production position of the measurement of the completion of the three-way valve.

The operation and management of MVI56-PDPMV1 is mainly through SunyTech industrial control application software to achieve the human-machine interface function. By monitoring the working condition of the metering station, the operator can monitor the whole process of automatic metering and control which well participates in automatic metering, as well as designate a single well to carry out designated metering, etc. The HMI screen includes the general view of the metering station, the selection of automatic metering, and the designation of single-well metering. The metering station overview screen is used to monitor the real-time operation of the metering station (as shown in the figure below), the automatic metering screen is used to select and set the well number to participate in automatic metering, and the single-well metering screen is used to set the single well to be designated for metering. The system also generates a daily report of the metering data of the metering station based on the daily metering situation.

The MVI56-PDPMV1 acts as a server, i.e., it is accessible to a remote computer (client), and the PLC does not need to write any communication programme. Therefore, all channels are configured as servers and “accept all connection requests”, meaning that the IP address of the remote client does not need to be specified. Otherwise, you need to specify the IP address of the remote machine to be accessed. Pay special attention to the “Local Properties TSAP 10.01” of each connection channel. The port number is different for each connection channel, because some host software requires this port number for communication.