SCXI-1324 Master Device Data Transmission Module

SCXI-1324

If you need to inquire or purchase ,please send the product models to my email or call me directly .

Contact detail:

Xiamen Xiongba E-commerce Co., Ltd

Mobile/ WeChat/ WhatsApp:+86-133 6590 9307

E-mail: geabbamy@gmail.com

Contact: Simon Zhang

Website: https://www.dcsplcsystem.com

Address: Unit 2008, Chuangxiang Center, No. 1733, Luling Road, Siming District, Xiamen, Fujian

Categories: ,
Get a quote, please contact me immediately:
Simon Zhang
dcsplcsales@gmail.com
Phone/Whatsapp/Skype/Wechat: +86 133 6590 9307

Description

SCXI-1324 Master Device Data Transmission Module


SCXI-1324 inverter controller system principle through the inverter system current and voltage through the voltage Hall sensor and current sampling circuit were detected, sent to the analog signal processing circuit for analog filtering and amplitude adjustment, the processed signal is sent to the DSP chip, through the 12-bit A/D converter module within the DSP chip, into digital signals, the DSP digital filtering of the signal to determine the output voltage and current of the single-phase half-bridge whether the over-voltage or overcurrent and to take the appropriate protective measures

The SCXI-1324 master device sends data to the GPRS module when the GPRS module sends the signal to the GPRS network, the master device must indicate the destination address of the data, only then the network in the figure above can select the route for data transmission, processing and transmission of this set of data. The network transmits this data to the destination GPRS module, which then transmits the data to the connected slave device. The difference between the two transmission methods is that the RS485 bus does not use the destination address during transmission, it is a broadcast transmission method.

The GPRS network of the SCXI-1324 selects the transmission route according to the destination address of the data at the beginning of the transmission, which is a point-to-point transmission method for each transmission. When using a GPRS module to organize a network, the destination address of the data transmission must be given according to the data format of the GPRS module. Therefore, the transmission format of the GPRS module cannot be transparent. In RS485 bus communication, in order to avoid data conflict on the bus, it is necessary to use question-and-answer communication. GPRS network, on the other hand, allows many sites to send data to one site simultaneously. The ordering of data arriving at the destination site is accomplished by the network.