T8110B each circuit is very important, the requirements must be quickly and accurately determine the point of failure when the first scheme is better; in general the third scheme is better, due to the fault classification alarm display, you can directly determine the nature of the fault, know what impact on the equipment or industrial process, you can take immediate measures to deal with it, and at the same time, combined with other phenomena, factors, another set of alarm conditions from this type of classification of specific faults. At the same time, it can be combined with other phenomena, factors, another set of alarm conditions or several sets of alarms to classify the specific point of failure from this category.

Parameter Controller
T8110B of the upper and lower two lines of digital tubes were to control the cut length and cut the number of rows will be set with blinking indicated, press the “start to determine” key to switch the position of the input. Input numbers can directly modify the corresponding parameters. If there is a mistake during the input process, you can press the “Cancel” key to delete the entered data and return to the display of the original parameters. If the control quantity is set to 100, then

T8110B operation mode:
1-Press the “Control Setting” key to enter the “Control Parameter Setting Status” in the manual state.
2-Press the “Start OK” key to make the lower line display (number of controls) blink.
3 – Key in the following sequence: “1 key”, “0 key”, “0 key”.
4-Press the “Start OK” key to write the entered parameters to the controller. Data setting is completed, press “reset” key to exit the “control parameter” setting state.
5 Press “Clear Quantity” to clear the current number of sheets; press “Clear Length” to clear the current length.